Should You Wear Glasses in a Self-Tape? Glare, Contacts, and Reading Your Sides
Leave your glasses off unless the role calls for them or they’re part of the look you’re known for. If you do wear them, glare is a lighting problem with lighting fixes: raise the light, move it to the side, tilt the frames a little. And if you need them to read your sides, that’s the best reason yet to be off book.
The Offbook team
Nov 19, 2026 · 8 min read
You’ve set up the ring light, framed the shot, and pressed record. On playback, there are two glowing white circles where your eyes should be. You can see the light, the window, and a tiny reflection of your phone. You can’t see you.
So you take the glasses off, and now you can’t read the sides on the music stand.
The short version: leave glasses off unless the breakdown calls for them or they’re part of the look casting already knows you by. If you keep them, glare is fixable: it comes from where your light sits, so move the light higher and off to one side, and tilt the frames a few degrees. If the problem is reading the sides, fix that with preparation, not glasses: get the lines into your body so the page is a backup you barely touch.
The plain rule: off, unless there’s a reason
Start with the breakdown and the casting instructions, because they beat any general advice. Acting Magazine’s guide to glasses in a self-tape puts that first: read the character description carefully before you decide. If it mentions glasses, wearing them helps casting picture the role. If it describes a look without them, leave them off unless they add something important.
When the breakdown says nothing, the guide suggests thinking about what glasses would say about the character. It also notes that casting directors often prefer a versatile, neutral look, so unless the character calls for glasses, leaving them off may be the safer choice. It’s careful to say this isn’t a hard rule, and that some casting directors like seeing how an actor really looks.
That gives you three honest reasons to keep them on:
- The breakdown or the instructions ask for glasses, or the character obviously wears them (a scene where the character takes them off to cry, or cleans them while stalling).
- Your glasses are part of your known look: they’re in your headshots and on your other tapes, and casting would be surprised to see you without them.
- You genuinely need them to see your reader or your mark, and contacts aren’t an option.
“I’m used to them” or “I feel more like myself” are fine reasons in life and weaker ones on tape. If they’re not on that list, try a take without them and compare.
Stay consistent with your other materials
The Acting Magazine piece also makes a point that’s easy to miss: if you usually audition without glasses, keep it that way, because big changes in how you look from one audition to the next can confuse people. The same works in reverse. If your headshot shows you in frames, a tape without them isn’t wrong, but it should be a choice for the role, not an accident.
Why glasses glare, in one sentence
Your lenses are small mirrors: light that hits them bounces off at the same angle on the other side, and if that bounce lines up with the camera, the camera sees the light instead of your eyes.
That’s why a ring light is the worst offender. It sits right around the lens at eye level, pointing straight at your face, so its reflection bounces straight back into the camera. A lamp in front of you at the same height does the same thing. Every fix below works by changing that angle, so the reflection goes somewhere the camera isn’t.
It also means you can find the problem before you shoot. Put the glasses on, sit in your spot, and look at the camera’s screen, or at the phone’s selfie view. Where you see the light in your lenses, you’ve found the light to move.
Fix glare by moving the light, not by squinting
Video shooters have a go-to move for this. No Film School’s write-up of a glasses-lighting tutorial calls it going “up and over”: raise the light, angle it down, and move it off to the side until the reflection disappears. Wistia’s video team gives the same advice in their guide to glasses on video: raise the key lights as high as possible and angle them slightly away from the camera.
For a home self-tape setup, that looks like this:
- Take the ring light off the phone mount and put it on its own stand, or set your lamp on a shelf. Raise it above your eye line, angled down at your face.
- Move it off to one side of the camera, somewhere between a little and about halfway around, watching the screen. Stop when the reflection slides off the lenses.
- If one side of your face is now too dark, add fill on that side: a second, dimmer light, or a white surface like a foam board or a pillowcase over a chair to bounce some light back.
- Shoot a ten-second test, play it back full screen, and check both lenses before the real takes.
Both guides add a warning: higher, side-on light can throw harder shadows. No Film School suggests filling them with a reflector, and Wistia notes that a bigger light source gives less glare. If you have a softbox, or can bounce your light off a white wall, that helps. Our self-tape lighting guide covers key and fill in more detail.
If you’re shooting by a window, the same rule applies. Facing a window straight on puts a bright rectangle in each lens. Turn so the window is off to one side of the camera instead.
Tilt the frames, and other small fixes
When you can’t move the light far enough, move the glasses. One tip in the Wistia guide is to ask talent to lift the back of the frames, the part behind the ears, slightly, which changes the angle of the lenses. No Film School’s version is to tilt them down a little, using bobby pins or tape to hold the arms in place if they keep slipping.
A few degrees is usually enough. Watch the screen while you lift the arms, and stop as soon as the reflection moves off. Too much and the glasses look crooked, which pulls focus in a different way.
Lowering your chin slightly can do the same job, but be careful with that one. It changes your eyeline and how you hold your head in every take, and it can make you look like you’re peering. Fix the light first.
Frames that slide are the other problem. Acting Magazine’s guide warns that glasses you keep pushing up can break the flow of a scene. Tighten them before you tape, or tuck the arms more firmly, so you’re never fixing them mid-line.
Contacts and lens-free frames
If the character needs glasses and the glare won’t go away, there are workarounds. The Acting Magazine guide suggests contact lenses, which avoid the glare problem, or a non-prescription pair with anti-glare lenses (test them on camera, since a coating alone may not stop the reflection), or frames with no lenses in them. Empty frames give casting the look without any reflection. Just make sure nobody can tell they’re empty, especially if you touch your face.
If you need glasses to read your sides, get off book
This case gets less attention: you can see the camera fine, but you can’t read a page held low without your reading glasses. Putting them on to read, then looking up through them at your reader, gives you the worst of both: glare and a head bob down to the page.
The real fix is not needing the page much. The Actors Access help center’s self-tape tips recommend memorizing your sides before you tape, so you can perform without holding them. Acting Magazine’s guide on being off book for a self-tape is more forgiving, calling it ideal but not required, and says the performance matters more than every word. Either way, the less you look down, the better.
If you only have a day, our guide to getting off book for a self-tape has a short-notice plan. Offbook helps with exactly this part: upload the sides, pick your role, and the other characters’ lines are read aloud while you say yours. Hide your lines as you go, as the video below shows, until you can run the scene with nothing in front of you but the cues you hear.
If you still need the pages as a safety net, make them easy to read without glasses. Print them in a larger font, highlight your lines, and hold them close to eye level just out of frame. Joey Madia’s self-tape strategies on Stage 32 describe the move: keep your thumb on your place, glance, look up, deliver the line. Our guide to holding your sides covers it in more detail.
A five-minute glasses check before you tape
Run this once you’re set up, before the first real take:
- Read the breakdown and instructions again. Do they mention glasses, or a look that rules them out?
- Shoot ten seconds with glasses and ten without. Watch both full screen. Which one shows your eyes better?
- If they stay on, find every reflection in the lenses and move the light that causes it: higher, then to the side.
- Check for slipping: do a big reaction from the scene and see if the frames move.
- Check your sides: can you read them at the distance you’ll hold them, without the glasses?
- Match what you’re wearing to the rest of the look. Our guide to what to wear to an audition covers the clothes.
Then forget about them. The Acting Magazine guide ends where every self-tape guide should: casting is watching whether you can bring the character to life. Glasses only matter when they get in the way of that.
Questions actors ask
Should I wear my glasses in a self-tape?
Only if the breakdown calls for them, the character clearly wears them, or they’re part of your known look in your headshots and other tapes. Otherwise, a neutral look without them is the safer default. If you wear them, check the playback for glare and fix it with the light, not by squinting.
How do I stop glare on my glasses in a self-tape?
Move the light up and to the side, so its reflection bounces away from the camera. A ring light right around the lens is the usual cause. If you can’t move the light far enough, lift the arms of the frames slightly behind your ears to change the angle of the lenses, and check on the screen until the reflection disappears.
Should I wear glasses if the character wears them?
It can help casting picture you in the role, and Acting Magazine’s guide suggests wearing them when the breakdown mentions them. If glare is a problem, the same guide suggests contact lenses, non-prescription frames with anti-glare lenses, or frames with no lenses at all.
How do I read my sides if I need reading glasses?
The best answer is to be as close to off book as you can, so you barely look down. As a backup, print the sides in a large font, highlight your lines, and hold them close to eye level just out of frame. Avoid putting glasses on and off between lines.
Do blue-light or anti-glare lenses stop reflections on camera?
Acting Magazine’s guide mentions anti-glare lenses, but don’t count on a coating alone to solve it. Light placement is what decides whether a reflection reaches the camera, so shoot a test with your own glasses and your own setup. If the reflection is still there, move the light.
Free tool · No account needed
Try it: run a scene right here
Pick a classic scene and a part. The voices read the other lines, and the scene waits for yours. No account needed.
Do this with your own script
Upload a PDF or a photo of your script, and AI voices read every other part and wait for your line.
Keep reading
- What to Expect at a Costume Fitting (and How to Prepare)Who’s in the room, what to wear underneath, why you’ll be asked to lunge in a half-finished jacket, how to raise a problem without insulting anyone’s work, and whether union fittings are paid.
- How to Self-Tape a Scene With Movement (Walk-and-Talks, Entrances, and Exits)The sides say they walk and talk, or she crosses to the window, or he storms out. Your camera sits on a tripod in a spare room. How to decide what to actually move, how to cheat a walk in place, how to frame an entrance or an exit, and how to keep your eyeline and your light while you do it.
- Why Can’t I Remember My Lines? 7 Common Causes and FixesForgetting lines is usually a method problem, not a talent problem. Seven common causes, from rereading to sleep, the memory research behind each, and what to do tonight.
- How to Self-Tape With a Laptop Webcam (and When to Use Your Phone Instead)A laptop webcam can make a usable self-tape if you raise it to eye level, light your face, sit close for sound, and check the file. Here is how to set it up, how it compares to your phone, and a split setup that works well: phone for the camera, laptop for the sides and the reader.