Auditions

Self-Tape Framing: How Close, How Much Headroom, and When to Go Wide

The default self-tape frame is chest to just above the head, in landscape, but the request always wins. Here’s how to read the instructions, how much headroom to leave, where your eyes should sit, when to go waist up or full body, and a two-minute check that catches framing mistakes before you record the take.

The Offbook team

Nov 15, 2026 · 9 min read

You’ve propped the phone on a stack of books, hit record, and done the scene. Then you watch it back. Your head is floating in the bottom half of the screen with a lot of wall above it. Or your chin is cut off and the top of your head is gone. Or you’re so far back you look like you’re auditioning from across the street.

Framing is the part of a self-tape most actors set by feel and never check. It’s also the first thing casting sees, before you say a word. Get it right and nobody notices. Get it wrong and the frame is all they can notice.

The short version: read the request first and do what it asks. When it asks for nothing, frame from your chest to just above the top of your head, in landscape, with a little headroom and your eyes about a third of the way down the screen. Go waist up only when the scene moves, and full body only when the request asks for it. Then record a ten-second test and check it before the real take.

The request decides the frame

The self-tape guides from Spotlight and Actors Access start from the same rule, and it’s easy to skip. The instructions on the request beat any default. Spotlight’s how to self-tape guide says to frame a mid-close shot “unless requested otherwise,” and the Actors Access help center’s tips for shooting self-tape auditions gives its default only “unless otherwise specified by the Casting Director.”

So before you touch the tripod, read the whole request with framing in mind. Look for these words:

  • A frame size: “close-up,” “mid-shot,” “chest up,” “waist up,” “full length,” or “full body.”
  • An orientation: “landscape,” “horizontal,” or, rarely, “vertical.”
  • A separate shot: a full-body shot at the slate, a profile, or a turn.
  • A position note: “seated,” “standing,” or a stage direction that puts you at a desk or in a car.

If the request asks for something unusual, follow it exactly, even if it goes against everything below. If two parts of it seem to conflict, the specific note beats the general one. A request that says “close-up, with a full-body shot at the slate” wants both, at two different moments.

The default frame: chest to just above your head

When the request is silent, the sources agree closely. Spotlight defines its mid-close shot as “from your chest to the top of your head.” Actors Access calls it a “moderate close-up,” from the chest to just above the head, because that’s the size that best shows your face and what you’re feeling. The agent.co.uk self-tape tips for actors describe the same thing as a mid-shot, roughly mid-chest to just above the top of your head.

That frame is a medium close-up, and it’s built for one job: letting casting watch you think. Your eyes and face carry the scene. Your shoulders and breath are there to show the body is alive. Your hands mostly aren’t, and that’s fine, because a self-tape isn’t the place for big gestures.

Both ends of the frame matter. Too wide, and agent.co.uk’s warning applies: your face gets small on screen, and the thing casting most wants to see shrinks. Too tight, and you get cut off awkwardly the first time you lean in. Chest up gives you a little room to move without leaving the shot.

If you want the acting side of this, what to play bigger or smaller at each size, our guide to acting for shot sizes covers it. This piece is about getting the frame itself right.

How much headroom to leave

Headroom is the space between the top of your head and the top of the frame, as the UNC Libraries Media Design Center’s video concepts guide defines it. Self-tape guides keep it short: agent.co.uk says to leave “a small amount,” and Acting Magazine’s piece on vertical and horizontal self-tapes says to avoid too much headroom as well as cutting off your head or shoulders.

Film-school composition explains why both mistakes hurt. The City College of San Francisco video production handbook says too much headroom makes the subject look too low in the frame and less important. Too little can cut off the head when the person moves, or make the shot feel cramped.

The easiest way to judge it is by your eyes, not the top of your head. The UNC guide suggests placing the eyes about a third of the way down from the top of the image, the rule of thirds. In a chest-up frame, that lands you with a sliver of space above your hair and your chin comfortably clear of the bottom.

Many phone cameras can show a three-by-three grid in the camera settings. Turn it on. Put your eyes on or just below the top line, and the headroom mostly sets itself.

Leave room on the side you look toward

Your reader usually stands just to one side of the lens, so your eyes point slightly left or right of camera for the whole scene. The same handbook calls the space in front of a subject’s face nose room, and says too little of it makes the frame feel unbalanced. In practice, center yourself, then let the frame sit a touch toward the side you’re looking, so your gaze has somewhere to go. Where exactly to look is its own subject, and our guide to being a good self-tape reader covers where the reader should stand.

Landscape, almost always

Turn the phone on its side. Spotlight’s guide says to film in landscape, not portrait, and its guide to filming young performer self-tapes adds the practical reason: portrait files cause problems for casting directors uploading them to the sites they use to process tapes. Actors Access also tells you to turn off your phone’s portrait orientation lock, so the phone actually records in landscape instead of footage that looks sideways, upside down, or too small.

Acting Magazine says the same: horizontal is the industry standard, and vertical is only for the rare request that asks for it, often for social media or promotional content. If a request does ask for vertical, its suggested frame changes to head and shoulders, like a portrait.

Orientation and camera height go together, and we cover both in self-tape camera height and orientation. The short rule for framing: get the phone level at your eyes first, then set the distance to get your frame. Don’t fix framing by tilting the phone up or down.

When to go wider: waist up and full body

The default is a starting point, not a rule for every scene. There are a few honest reasons to widen it.

Waist up, when the scene moves

If the scene has real movement in it, such as a character who paces, picks something up, or turns away, a chest-up frame will lose it. Widening to waist up gives the movement room without shrinking your face too far. For a speech that moves, such as a classical monologue, our guide to self-taping a Shakespeare monologue suggests a waist-up default for the same reason.

Widen only as much as the movement needs, and test it. If you’re moving to fill a wider frame, you’ve got it backwards. The scene decides the frame, not the other way round.

Full body, when they ask

Some requests ask for a full-body shot, sometimes at the slate rather than during the scene. Unless yours does, you don’t need one. Spotlight’s young performer guide gives a clean way to shoot it: film a wide shot of the performer and then walk forward to get a close-up. If the whole body won’t fit in a landscape frame, the same guide says to tilt the camera up and down to show it. That’s the one exception to keeping the phone level, and it’s only for the full-body shot.

Here’s our own tip for doing it alone: mark two spots on the floor with tape, one for the full-body shot and one for your close-up. Start on the far mark, then walk forward to the near one. If the wide shot fits in landscape, the phone stays put and you land exactly in frame.

For the slate itself, what to say and where to look, see how to slate for a self-tape.

Hold the frame for the whole take

A good frame at the start of a take can be a bad one by the end. The usual causes are small and fixable:

  • You drift. You lean in on the big moment and your chin leaves the bottom of the frame, or you step back and your face shrinks. A tape mark for your feet keeps you planted.
  • You change height. Spotlight’s young performer guide says to sit for the whole recording or stand for the whole recording, because switching looks messy in a mid-close frame. Our guide on whether to sit or stand in a self-tape helps you choose.
  • You look down at the script. Your face tips out of the frame you built, and casting gets the top of your head. This is the one that only memory fixes.
  • The phone moves. A phone leaning on books slides as you record. A cheap tripod or phone clamp is worth more than any lens.

That third one is easy to miss. You can set the camera perfectly and still spend half the take looking out of it. The fix is knowing the sides well enough that your eyes stay up. Offbook helps with exactly that: realistic voices read the other parts and wait for your line, and you can hide your own lines while everyone else’s stay visible, so you test what you actually know before you tape.

Hide your lines · 1:07 · Watch with chapters and transcript

For a fast first pass on a short side, our free first-letter line memorizer turns your lines into first-letter cues, and the run lines online tool lets you rehearse a classic scene with a voice that waits for you.

A quick frame check before the real take

Don’t judge the frame on the phone screen while you’re standing at your mark. You can’t see it properly from there, and you’ll be looking at the screen instead of acting. Record a short test instead and watch it back. Here’s the check, in order:

  1. Read the request one more time for frame size, orientation, and any separate shots.
  2. Unless the request asks for vertical, turn the phone to landscape and turn off portrait lock. Turn on the camera grid.
  3. Set the phone at your eye level, pointed straight at you, not tilted up or down.
  4. Stand or sit on your mark and record ten seconds of the scene’s biggest moment, the one where you’re most likely to move.
  5. Watch it back. Your eyes should sit near the top grid line, with a little space above your head. Unless the request asks for a different size, the frame should cut across your chest.
  6. Check the edges. Is anything distracting in the frame? Did your chin leave the bottom when you leaned in? Is there room on the side you’re looking toward?
  7. Move the phone closer or farther rather than tilting it, then record the test again until it’s right.
  8. Mark the phone’s spot and your spot with tape, so the next take and the next audition start from the same frame.

The first time, this takes a few minutes. After that, with tape on the floor and on the shelf, it takes one test clip. It’s one of the cheapest fixes a self-tape has.

Questions actors ask

Should a self-tape be chest up or waist up?

Chest up, to just above your head, unless the request says otherwise. That’s the default in Spotlight’s and Actors Access’s guidance. Go waist up when the scene has real movement that a chest-up frame would cut off.

How much headroom should a self-tape have?

A little. Put your eyes about a third of the way down from the top of the frame, and you’ll end up with a small gap above your head. Lots of wall above you makes you sit low in the frame and look less important; no gap at all cuts you off when you move.

When should I do a full-body shot?

When the request asks for one, usually at the slate. Film it wide, then walk forward to your close-up mark. Don’t do the whole scene full body unless you’re told to.

Can I film a self-tape vertically?

Only if the request asks for vertical. Horizontal is the industry standard, and portrait files can cause trouble on the sites casting uses to process tapes.

How far should the phone be from me?

As far as it takes to get the frame the request asks for, and no farther. If you’re using the phone’s built-in microphone, Spotlight warns against going too far from the camera, so a tight default frame also helps your sound.

Free tool · No account needed

Try it: run a scene right here

Pick a classic scene and a part. The voices read the other lines, and the scene waits for yours. No account needed.

Open the full run lines tool

Do this with your own script

Upload a PDF or a photo of your script, and AI voices read every other part and wait for your line.

Rehearse your own script

Keep reading